Via Bluetooth - iOS
This article will assist you in connecting a Trackside Bluetooth QR Scanner to an iOS Bluetooth device.
Pairing issue? Hold down trigger for 8 seconds to force Bluetooth pairing. Keep holding until the QR scanner beeps.
If you need the full QR Scanner Connection Sheet, it's available in My Scanner Won't Connect by Bluetooth.
Want a different type of connection or having Bluetooth issues? See Via USB Dongle or Via Wired USB.
iOS:
Step 1 - Enter Settings
Enter Settings.
Step 2 - Select Bluetooth
Select Bluetooth
Step 3 - Ensure Bluetooth is Enabled
Ensure Bluetooth is Enabled
Step 4 - ScanPlace CodesScanner into Bluetooth Search Mode
Pull the scanner trigger once to wake it up, then hold the trigger for 8 seconds until the scanner beeps. This will place it in Bluetooth Search Mode, and should be accompanied by a flashing blue & green light on Setup Sheet w/ Scanner
Use scanner to scan codes from top to bottom under Enable Bluetooth Scanning on page 1 of the Trackside QR Scanner Setup Sheet.
Step 5 - Select Scanner on Your Device
Select Barcode Scanner HID on the Bluetooth device. ThisIf willthe scanner isn't showing up, you may need to berefresh donethe within a few secondslist of scanning the QR codes on the Setup Sheet.devices.
Step 6 - Listen for Pairing Complete Beep
Listen for pairing complete beep.
Note - On Screen Keyboard
On Screen Keyboard should disappear. Double pull scanner trigger to activate/deactivate on screen keyboard.
If these steps aren't working, there are additional troubleshooting steps in My Scanner Won't Connect by Bluetooth .